2000 Series Model LED Explosion–Proof LED Warning Light


2000 Series Model LEDExplosion–Proof LED Warning Light
DESIGNED FOR USE IN ATEX ZONE RATED ATMOSPHERES
View all cut sheets
View all instruction sheets

Get Acrobat ReaderDownload Acrobat Reader
Federal Signal uses the PDF format for the electronic distribution of this documentation. The free Adobe Acrobat Reader allows you to view, navigate, and print PDF files across all major computing platforms. You will need the Acrobat Reader in order to view the above files.
Super bright output with XLT™ Technology
Three remotely selectable flash patterns
50,000 hour lamp life
Available in five colors
Ex 'e' terminal chamber available
AC and DC voltage ranges
Approved for use in Zone 1, 2, 21, 22 atmospheres

The 2000 Series model LED beacon, with XLT™ technology, is a visual signal warning light for use in hazardous locations requiring ATEX approval. The beacon can produce three light patterns depending on the configuration of a field selectable jumper wire or remote contact closure. The light patterns are: steady–on, slow flash and rapid flash. An optional telephone initiation feature also allows the beacon to flash when telephone ringing voltage is present.
The 2000 Series LED beacon is sealed from dust and water by a nitrile rubber o–ring seal. All exterior cast aluminum surfaces are finished in powder coat paint and external hardware is manufactured from stainless steel to resist corrosion. Available signal colors are amber, blue, green, red and yellow.
The 2000 Series LED beacon is externally powered by 24VDC or 110–240VAC source. All AC powered units feature a switch mode power supply that accommodates a wide input voltage range without requiring any additional configuration from the user. The current consumption from the beacon is less than 500mA and the in–rush current is low enough to allow PLC initiation without the use of an external relay. Screw type terminal blocks are provided for field wiring on all units.
All variations of the 2000 Series LED beacon feature a four entry fixture to allow cable looping. These cable entries are metric M20 X 1.5, but other configurations are available upon request.